LL200 Compressor Installation
10
332230T
7. Remove oil breather from compressor. Pour 4 oz.
of included compressor oil into compressor
through breather port. Verify oil is above red dot in
sight glass.
NOTE:
Oil level will change at a slower rate than poured
as it descends into the crankcase. Pour small amounts
at a time, checking between pours.
8. Remove hopper. Locate belt shroud. Loosen knob
and rotate shroud.
9. Using a 1/4 in. Allen wrench, remove shoulder bolts
and serrated nuts securing existing coupler plate.
NOTE:
Do
not
use ball end Allen wrenches, as they
may break and become stuck in the screws.
10. Assure pump shaft extends 0.125-0.225 in.
(3.175-5.73 mm) beyond the face of the pulley. The
pump shaft is the pilot for the coupler adapter. If
necessary loosen set screws on pulley and slide
pulley along pump shaft, torque set screws to
58-62 in-lb (6.6-7 N•m).
NOTE:
Before performing step 13, secure nuts to back of
pulley with piece of duct tape to assist with installation.
11. Install shaft coupler (5) onto pulley with two
shoulder screws (18) and serrated nuts (19).
Position slot on back of pulley up and move
serrated nut with finger to accept shoulder bolt
threads. Tighten shoulder bolt by hand until the
teeth on the serrated nut catch the aluminum on the
fan. Using a 1/4 in. Allen wrench, torque to 16-18
ft-lb (21-24 N•m). Put belt shroud down.
NOTICE
Failure to properly fill compressor with oil can result in
failure and/or severe catastrophic damage to the
compressor.
