Max Model Setup
332305G
39
Uploading Pump Program
Settings to the Pump
1.
Plug the USB flash drive into the USB port.
NOTE:
•
The USB flash drive must contain file
GRACO/G3Config/g3config.bin.
•
The G3 pump stops pumping as soon as the
USB flash drive is plugged into it.
2.
The system automatically begins downloading data
to the USB drive.
3.
“data” is displayed while the system
is downloading files.
4.
When download is finished, “done” is
displayed.
5.
G3 pump restarts cycle in the OFF mode.
6.
After the download is com-
plete, press and hold the
RESET button and UP
ARROW button for 3 seconds
to upload the setup stored in the USB flash drive.
7.
“data” is displayed while the unit is
uploading the configuration data.
8.
When upload is finished, “done” is
displayed.
9.
G3 pump restarts cycle in the OFF mode.
10. Remove the USB flash drive.
11. After the USB flash drive is
removed, press and hold the
UP and DOWN ARROW but-
tons for 3 seconds to enter
the SETUP MODE (see
Entering Setup Mode, page 30).
12. In SETUP MODE, set the YEAR, MONTH, DATE
and TIME (see Setting the Real Time Clock, page
31).
13. After pressing the ENTER button to set
the TIME, press the RESET button to
exit the SETUP MODE.
Viewing the UNIT DMS ID Number
1.
In RUN mode, press and hold the
DOWN ARROW button.
2.
The Unit DMS ID number displays. The
unit continues to normal operation while
the DMS ID is displayed.
3.
Release the DOWN ARROW button after viewing
the DMS ID number.