Graco EM5 238457, Instructions-Parts List Manual

Page: 4 / 24

4 308487
Installation
Typical Installations
Fig. 1 shows a typical hose reel installation. Fig. 2
shows how these dispense valves can be installed on
a console.
Do not use this electronic metered dispense
valve on non-Graco consoles. Such use could
result in the trigger becoming inadvertently
pressed while the dispense valve is stowed.
CAUTION
Fig. 1
L
M
K
N
J
06174B
H
KEY DESCRIPTION
H Thermal relief kit (required) Part No. 235998
Install downstream from pump.
J Fluid shut-off valve
K Hose
L Hose reel fluid inlet hose
M Hose reel
N Metered dispense valve
The typical installation shown in Fig. 1 is only a guide;
it is not a complete system design. Contact your
Graco distributor for assistance in designing a system
to suit your particular needs.
This dispense valve is not designed for in-line
installation. Do not install with a shut-off valve
on the outlet side of the meter. Such installation
could result in damage to the meter housing
cover.
CAUTION
Mounting Bracket
Mounting bracket 196471 is available for resting an
EM5 dispense valve on a console. See Fig. 2.
Do not obstruct the trigger of this dispense
valve, and do not set the unit down resting on its
trigger, or it might not stop dispensing.
CAUTION
Fig. 2
mounting
bracket
196471
NOTE: When using the EM5 with the rigid oil
extension on a dispense console, the rigid tube (5a)
should be oriented with the 75
_
bend closest to the
nozzle, as shown below. This prevents interference
when used with a dispense console.
5a
5a
TI0274