![background image](http://html.mh-extra.com/html/graco/309028zat/309028zat_instructions-manual_2251521055.webp)
Troubleshooting
309028ZAT
55
Pneumatic Logic Panel Troubleshooting
Problem
Cause
Solution
Ram will not move up or down.
Main air valve on box is not open.
Air supply to unit is not on.
Open valve.
Turn on air supply.
Ram will not move up.
Direction valve is not in the UP
position.
RAM UP Pushbutton (AF) is not
pushed. Resistance in drum is too
great.
Insufficient lubrication of the
Follower Plate seal.
Set direction valve to the UP
position.
Push RAM UP Pushbutton (AF).
Turn air pressure up to 60 psi. The
ram may take a few minutes to
withdraw from the container.
After the plate has been removed
from the container, clean the seal
and thoroughly lubricate.
Pumps will not operate.
Air regulator is set too low.
Increase air pressure setting.
Vent valve will not open.
FOLLOWER VENT switch is not in
AUTO position.
Put FOLLOWER VENT switch in
AUTO position.
Summary of Contents for 309028ZAT
