Ram Assembly Service
46
309028ZAT
Ram Piston Service
1. Relieve the air pressure. Follow the
on page 35.
2. Remove the tie bar as explained in the
section on page 45.
3. Remove the guide sleeve and slide it off of the
piston rod.
4. Carefully pull the piston rod straight
up out of the
cylinder. If the rod is cocked to one side, the piston
or inside surfaces of the cylinder could be damaged.
5. Carefully lay the piston and rod down so the rod will
not be damaged or bent. Remove the lower piston
retaining ring. Slide the piston off the piston rod.
6. Install new O-ring seals on the piston rod and the
piston. Lubricate the piston and seals. Reinstall the
piston and retaining ring.
7. Carefully insert the piston into the cylinder and push
the rod straight down into the cylinder. Add 3
ounces of lubricant to each cylinder after inserting
the piston.
8. Slide the guide sleeve onto the piston rod. Reinstall
the retaining ring and tie bar, as explained under
Do not use pressurized air to remove the guide sleeve
or piston. Failure to follow this instruction may result
in personal injury.
F
IG
. 25
7056A
Band
Piston
Ring
O-ring
O-ring
Ring
Summary of Contents for 309028ZAT
