Setup
3A7467D
17
Fill Pot with Abrasive Media
1. Verify that the pot seal plunger (F) is in the DOWN
position. If the plunger is in the up position, perform
the
2. Verify that
3. Close the rinse ball valve (X) and the abrasive ball
valve (M).
4. Turn the selector valve (W) to OFF.
5. Open the pot dump valve (J).
6. Open the quick drain valve (ZL).
7. Prepare the pot to accept media:
-
To fill an empty pot:
Fill approximately half the
pot (E) with water, until the water drains from
the quick drain valve (ZL). Shut the quick drain
valve.
-
To refill the pot during operation:
open the
quick drain valve (ZL) to drain the water until the
pot is approximately half full. Shut the quick
drain valve.
8. Add abrasive media to the pot.
NOTE:
The media level should be a few inches below
the pot seal plunger (F). Do not overfill the pot with
abrasive material, or the pot seal plunger will not be able
to seal.
NOTE:
As long as the abrasive media is below the
plunger, the water level can rise above the pot seal
plunger (F) without affecting performance.
F
IG
. 1: Turn the Selector Valve Off
F
IG
. 2: Open the Pot Dump Valve
WLD
W
WLD
J
ZL
X
F
IG
. 3: Fill the Pot
F
IG
. 4: Add Abrasive Media
ti37626a
E
J
ZL
ti37627a
F
Summary of Contents for 262960
Page 10: ...Component Identification 10 3A7467D Component Identification WL D WLL D 3 1 4 5 6 7 8 9 0 ...
Page 44: ...Parts 44 3A7467D EQ200T Parts WL F 1 Apply thread sealant to all non swivel pipe threads ...
Page 46: ...Parts 46 3A7467D EQ400T Parts 1 Apply thread sealant to all non swivel pipe threads ...
