Configuring Software
309738L
33
Configuring Software
After you have loaded material into the dispensing sys-
tem, configure the PrecisionFlo LT software. F
shows the major configuration steps.
The PrecisionFlo LT system compensates for tem-
perature, flow, or pressure fluctuations. However, if you
change hardware on the dispensing system or change
the type of material being dispensed, you must reconfig-
ure the PrecisionFlo LT software.
To configure the PrecisionFlo LT software, perform the
following procedure. When you have completed this pro-
cedure, the module is ready for operation.
1.
Select the desired control mode. See page 28.
2.
Calibrate the system. See page 34.
3.
Verify the flow meter K-Factor. See page 34.
4.
Verify other controller preset values. See page 37
for more information.
5.
The
PrecisionFlo LT User Interface
section on
page 27 gives detailed operating instructions for the
display keypad and each screen.
For more information regarding applications that
run continuously see
F
IG
. 16
Configure Software
Verify flow
meter K-factor
Calibrate
system
Set user and
system variables
Set dispense
on/off delays
End Software
Configuration
Select Control
Mode. Ref Page 27
Calibrate
system
