Edit 1 – Modulator 1 step 1 level:
Value: 0 to 255.
This value is only completely active, if the
morph control on Modulator 1 edit page I are in position zero, and morph modulation has the
value + 0.
Edit 2 – Modulator 1 step 1 Time:
Value: 0 to 255. The time it will take to reach the value of the
next step.
This value is only completely active, if the morph control on Modulator 1 edit page I
are in position zero, and morph modulation has the value + 0.
Encoder – Modulator 1 step 1 Will:
Determines what Modulator 1 will do, after step 1 has been
executed. Possibilities are:
-Sust:
It will sustain, and not loop, with this steps value, until it is re-triggered, then it will reset to
step 1.
-Cont:
It will continue to the next step.
-Loop:
It will loop – reset to step 1.
Edit 1 – Modulator 1 step 2 level:
Value: 0 to 255.
This value is only completely active, if the
morph control on Modulator 1 edit page I are in position zero, and morph modulation has the
value + 0.
Edit 2 – Modulator 1 step 2 Time:
Value: 0 to 255. The time it will take to reach the value of the
next step.
This value is only completely active, if the morph control on Modulator 1 edit page I
are in position zero, and morph modulation has the value + 0.
Encoder – Modulator 1 step 2 Will:
Determines what Modulator 1 will do, after step 2 has been
executed. Possibilities are:
-Sust:
It will sustain, and not loop, with this steps value, until it is re-triggered, then it will reset to
step 1.
-Cont:
It will continue to the next step.
-Loop:
It will loop – reset to step 1.
2 Stp1. Time. Will
X 255 20 Cont
3 Stp2. Time. Will
X 0 0 Cont
