Gorilla Playsets 1500CWR, Manual, Page: 44 / 119

STEP 1: ATTACHING T-NUTS TO THE CORNER POSTS
1: THIS STEP IS CRITICAL TO BUILDING THE FORT PROPERLY. IF ANY MISTAKES ARE MADE HERE, YOU WILL NEED TO
DIS-ASSEMBLE AND THEN RE-ASSEMBLE TO MAKE YOUR CORRECTIONS.
2: MAKE SURE HOLES ARE FREE OF ANY OBSTRUCTIONS. USE A BOLT TO CLEAN OUT ANY DEBRIS.
3: LAY OUT EACH OF THE 4 X 4 X 108" CORNER POSTS IN THE AREA YOU INTEND ON BUILDING THE FORT SIDE OF
THE PLAYSET.
4: USE THE DIAGRAM BELOW TO CORRECTLY IDENTIFY AND ORIENT THE DIRECTION THE POSTS SHOULD FACE.
5: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE DIAGRAM BELOW.
6: THE BARREL OF THE T-NUT SHOULD GO IN THE HOLE FIRST. HAMMER THE T-NUT UNTIL IT IS FLUSH/ALMOST FLUSH
TO THE CORNER POSTS.
SIDE OF FORT
CORNER POST
HOLES AT THE TOP
BOLTS)
FRONT OF FORT
BEAM MOUNT
(NOT USED)
USING 4 X 4 X 108"
T-NUT
CARRIAGE
LEFT (SWING BEAM)
OF CORNER POSTS
SHOULD BE FACING
THIS DIRECTION
NO T-NUT IN
THESE HOLES
(FOR SWING
NO T-NUT
IN THESE
HOLES
NO T-NUT
IN THIS
HOLE