9
8. Insert a Pad Tube (12) through the Leg Lever
(6). Slide a Foam Pad (13) onto each end of the
Pad Tube. Then, press a Pad Cap (34) into
each end of the Pad Tube.
Repeat this step with the other Pad Tube
(12), Foam Pads (13), and Pad Caps (34).
8
9. Insert a Weight Rest (15) into an Upright (1).
Rotate the Weight Rest so that the locking
pin is wrapped around the Upright.
Repeat this step with the other Weight Rest
(15). Make sure that the Weight Rests are at
the same height.
9
15
15
Locking
Pin
1
1
6
13
13
13
13
12
12
34
34
34
34
10. Orient the Backrest (8) as shown.
Orient the Backrest Tubes (7) so that the indi-
cated holes are in the position shown.
Attach the Backrest Tubes (7) to the Backrest
(8) with four M6 x 40mm Screws (32) and four
M6 Washers (22).
Do not tighten the Screws
yet.
10
8
7
Holes
22
32
32
22
