12
ADJUSTING THE WEIGHT RESTS
To change the height of the Weight Rests (15),
remove them from the Uprights (1) and insert them
into a different set of holes in the Uprights.
Rotate
the Weight Rests so that the locking pins are
wrapped around the Uprights.
Locking
Pin
Locking
Pin
15
1
15
1
WARNING:
Always rotate the
Weight Rests (15) so that the locking pins
are wrapped around the Uprights (1).
Always set both Weight Rests at the same
height.
USING THE CURL PAD
To use the Curl Pad (5), first remove the 50mm
Square Inner Cap (16) from the Front Leg (4).
Next, insert the Curl Post (11) into the Front Leg
(4), and tighten the Curl Knob (36) into the Front
Leg and into one of the adjustment holes in the Curl
Post.
Make sure that the Curl Knob is in one of
the holes in the Curl Post.
Note: When you are not using the Curl Pad (5),
remove the Curl Post (11) and insert the 50mm
Square Inner Cap (16) into the Front Leg (4).
11
16
36
4
5
