8
5. Attach the Frame (3) to the Crossbar (2) with
two M10 x 68mm Bolts (27) and two M10
Locknuts (31).
Do not tighten the Locknuts
yet.
5
6. Insert the Backrest Support (14) into one of the
three sets of holes in the Uprights (1).
Rotate
the Backrest Support so that the locking pin
is wrapped around the Upright (see the inset
drawing).
See steps 1, 2, 4, and 5. Tighten the M10
Locknuts (31) and the M8 Locknuts (38)
used in these steps.
6
1
1
14
Locking
Pin
3
2
31
27
7. Apply part of the included grease packet to an
M10 x 60mm Bolt (25).
Attach the Leg Lever (6) to the Front Leg (4) with
the M10 x 60mm Bolt (25) and an M10 Locknut
(31).
Do not overtighten the Locknut; the Leg
Lever must pivot easily.
7
25
31
Grease
6
4
Locking
Pin
