GEK-99044
A-3
Appendix A Unpacking Instructions
12.
Open the top cover of printer and remove the sheet of packing
material covering the control panel.
13.
Next, remove the foam packing block from between the paper
guides by cutting the plastic tie.
14.
To maintain stability in the printer during shipping two brackets
are used to attach the print mechanism to the frame.
THESE
MUST BE REMOVED BEFORE THE PRINTER IS PUT INTO
OPERATION!
Please study Figure A-5 (below) and follow the steps
listed below to remove the brackets. An Allen wrench is provided
in the manual kit for the removal of the screws.
15.
Open the front cabinet door. The shipping brackets are located on
the right and left sides of the cabinet. Three screws attach each
bracket - one on the top which it is attached to the print
mechanism and two on the bottom, which are attached to the
cabinet frame.
16.
Remove the screw holding the bracket to the print mechanism.
17.
Remove the two screws on the bottom of the shipping bracket.
Note
The brackets and screws, as well as the Allen wrench can be
reused if the printer is shipped to a new location at a future
date.
SHIPPING
BRACKET
SCREW LOCATIONS
PAPER CABINET
FIGURE A-5