Page 22
Loosen and remove the (2) M3 screws. (Do
not mislay these screws, they will be needed
for the new infeed guide.
Remove the air box infeed guide
Repeat the procedure for the infeed guide
insert in the other hosing half
To fit the new guides, reverse the disassem-
bly procedure
11.0 Procedure for changing the air box infeed guide
12.0 Procedure for changing the cable drive belts
There may be circumstances when a belt with much higher grip will be needed. If, for instance it is necessary
to install a cable, which will sustain crushing damage when light compression forces are applied to it. It will
be necessary to use a belt with a surface coating with high friction characteristics. This will allow the cable to
be pushed with high torque while being compressed lightly. Additionally, smaller cables may require a belt
with a smaller groove profile to gain the best grip possible. If these types of belt are needed the General Ma-
chine Products Co., Inc. sales office will be able to advise on part numbers etc. To fit these belts it will be
necessary to remove the standard belts, the procedure is as follows:
Remove the 4 screws retaining the belt guards.
