Page 10
Fit the microduct into which the cable is to be installed into the air box and mi-
croduct clamp.
It is recommended that a length of microduct similar in size to the microduct into which the cable is to be in-
stalled be fitted in the microduct clamp. This length of microduct may then be connected to the installed mi-
croduct (the length of microduct under-
ground into which the cable is to be in-
stalled) using a suitable connector.
Slide a suitable size O ring over the end
of the microduct.
Fit the microduct into the end of the air
box housing so that it protrudes approx.
half way into the housing, position the O
ring so that it sits against the seal face,
as shown in the illustration opposite.
Once the microduct has been posi-
tioned, the microduct clamp may be
closed, the swing bolt swung down and
the thumb nut tightened, the microduct
is now secure.
