![background image](http://html.mh-extra.com/html/gmc/vsl-4000/vsl-4000_installation-manual_2235897009.webp)
NVSL4000
9 - English
The (+) parking light wire is often found near the switch. Many cars have the switch built into the turn signal
lever, and in these cars the parking light wire can be found in the steering column. The same wire is often avail-
able in the kick panel or running board.
How to find a (+) parking light flash wire with your multimeter:
1. Set to DCV or DC voltage (12V or 20V is fine).
2. Attach the (-) probe of the meter to chassis ground.
3. Probe the wire you suspect of being the parking light wire.
Usually, the area near the headlight/parking light switch is an
excellent area to start, as is the kick panel.
4. Turn on the parking lights. If your meter shows (+)12V, turn off
the parking lights and make sure it goes back to zero.
5. If it does return to zero, turn the parking lights back on and, using the dash light dimmer control, turn the
brightness of the dash lights up and down. If the meter changes more than a volt when using the dimmer,
look for another wire. If it stays relatively close to (+)12V, you have found your parking light wire.
making your wiring connections
Before making your connections, plan how your wires will be routed through the vehicle. For instance, the yellow
ignition input, the red 12V constant input, and the orange ground-when-armed output will often be routed
together to the ignition switch harness. In order to keep the wiring neat and make it harder to find, you may
wish to wrap these wires together in electrical tape or conceal them in tubing similar to what the manufacturer
used.
There are two acceptable ways of making a wire connection - solder connections and crimp connectors. When
properly performed, either type of connection is reliable and trouble-free. Regardless of whether you solder your
connections or you use mechanical-type crimp-on connections, ensure that all connections are mechanically
sound and that they are insulated.
Cheap electrical tape, especially when poorly applied, is not a reliable insulator. It often falls off in hot weather.
Use good quality electrical tape or heat shrink.
■
Never twist-and-tape the wires together without soldering.
■
Never use “fuse taps”, as they can damage fuse box terminals.
If you use tapping connectors such as 3M T-Taps (not to be confused with Scotch-Locks), avoid using them in
higher-current applications (constant 12V, ground, etc.). Some tapping connectors are inferior in quality and
should be avoided.
finding a (+) parking light wire
Summary of Contents for VSL 4000
