![background image](http://html.mh-extra.com/html/gmc/camille-bauer-sineax-am2000/camille-bauer-sineax-am2000_device-handbook_2235742032.webp)
PM 1000087 000 12
Device handbook SINEAX AM2000
32/91
6.3.3 Connection of the IEC61850 interface
The RJ45 sockets X1 and X2 serve for direct connecting Ethernet cables. Both ports are equivalent and
internally connected via a switch.
Interface: RJ45 sockets, Ethernet 100BaseTX
Mode:
10/100 MBit/s, full / half duplex, Auto-negotiation
Protocols: IEC61850, NTP
Functionality of the LED's
•
LED green: On if a network connection (link) exists, flashes during communication
6.3.4 Connection of the PROFINET interface
The RJ45 sockets X1 and X2 serve for direct connecting Ethernet cables. Both ports are equivalent and
internally connected via a switch.
Note: The interface may only be connected to a local Profinet network, which is designed as SELV circuit
according to IEC 60950-1.
Interface: RJ45 sockets, Ethernet 100BaseTX
Mode:
10/100 MBit/s, full / half duplex, auto-negotiation
Protocols: PROFINET, LLDP, SNMP
Functionality of the LED's
LED
State
Meaning
X1 green
X2 green
OFF
No network connection
ON
Existing network connection
Flashing
Active communication
Red left
BF
(Bus failure)
OFF
No error
ON
No configuration, slow or no link
Flashing (2 Hz)
No data exchange
Red right
SF
(System failure)
OFF
No error
ON
Watchdog timeout, diagnosis active; System failure
Flashing (1 Hz, 3s)
DCP signal service via bus initiated