Page 12
Operating Instructions
HOW TO USE THE ATTACHMENT HUB
Never put your hand into the feed chute when using any mixer attachment.
Only operate the attachment hub in MANUAL mode.
DO NOT attempt to mix ingredients in the bowl while using the hub.
The mixer must be OFF before installing attachments! Do NOT use attachments while mixing!
1. Loosen and remove the attachment hub thumbscrew (see fig 12-1).
2. Remove the plastic cover from the attachment hub (see fig 12-1).
3. Lubricate the attachment shaft with a food quality grease or mineral oil.
4. Insert the attachment shaft into the hub making sure to line up the alignment pin with
the hub hole.
5. Tighten the thumbscrew back into the hub and securely tighten it.
6. Select the appropriate speed setting by lifting or lowering the speed control lever.
Recommended Speed while using attachments:
Attachment
Recommended Speed
Vegetable Slicer
1 or 2
Cheese Shredder/Grater
1 or 2
Meat Grinder
1 only
NOTE: Make sure the bowl is up and the bowl guard is closed. The mixer will not start if the bowl and the
bowl guard are not in the proper operating position.
7. Adjust the timer using the untimed operation described on the previous page.
8. Press the green start button located on the control panel.
Always STOP the mixer BEFORE changing speeds! Failure to do so may damage the
gears or other parts and WILL void the warranty!
9. To change the speed while using mixer attachments:
a.
press the red stop button, then wait for the agitator to come to a complete stop.
b. change the speed by raising or lowering the speed control lever
c. press the green start button to restart the mixer
NOTE: The SP62P and SP80PL will automatically shut off if
the speeds are changed while the mixer is in operation.
Plastic Cover
Thumbscrew
fig. 12-1
Summary of Contents for SP10
Page 2: ......
