Metis micro user manual v1.6
11
Input 2 can be configured with a response time. Response time means the time the input
has to in alarming state until the alarm is registered (see 6.4 –Input settings).
In addition to normal inputs, the device has a built-in tamper switch that alerts when the
enclosure is opened. The tamper switch can be disabled with a jumper (see 8 –
connections)
4.
4.
4.
4.4
4
4
4 Output
Output
Output
Output
me
me
me
me
tis
tis
tis
tis
Micro
Micro
Micro
Micro has a small relay that can be used to control external devices. Maximum load
for the relay is 24VDC/1A. Jumper 2 selects whether the relay acts as a local alarm
indicator or remotely controllable (see 8 – Connections).
When the alarm relay function is selected the relay gives a pulse (20s – 9min.) during an
alarm that can be used to control a siren for example.
When the remote control function is selected the relay can be controlled either via a
phone call or an SMS (the control commands are described in 7.1- relay control
commands)
For higher loads please use external relays. It is also recommended to use a diode over the
coil of the external relay to prevent harmful transients..
Note! Under any circumstances do not connect 230VAC volta
Note! Under any circumstances do not connect 230VAC volta
Note! Under any circumstances do not connect 230VAC volta
Note! Under any circumstances do not connect 230VAC voltage to the device.
ge to the device.
ge to the device.
ge to the device.
4.
4.
4.
4.5
5
5
5 Input arming and disarming
Input arming and disarming
Input arming and disarming
Input arming and disarming
Selected inputs can be armed / disarmed with a phone call (see. 6.9 – General settings /
6.5 – Arming and disarming).
Arming/disarming the device and relay controlling via phone call cannot be both used at
the same time. Please review settings to prevent the double function.
me
me
me
me
tis
tis
tis
tis
Micro
Micro
Micro
Micro can be armed / disarmed by calling the device from a number that is stored in
the device’s phonebook (see 5 – Phone numbers). During the call no voice channel is
opened, only the number is recognized. It is recommended to activate the
armed/disarmed state reporting to receive an SMS every time the state is changed (see 6.9
– General settings).