FIRE
FAULT
PRE-ALARM
TEST
DISABLED
SYSTEM ON
ALARM FAULT
SUPPLY FAULT
SYSTEM FAULT
TRANS. FAULT
PAPER FEED
LAMP TEST
SYSTEM RESET
INTERNAL BUZZER
SILENCE
DISABLED
TEST
FAULT
FIRE
AUXILIARY
RELAYS
SOUNDERS
ENABLE/DISABLE
SELECTED
DETECTORS
DELAYS
ACTIVE
STATUS
FAULTS
CONTROLS
DISABLEMENTS
QUEUE REVIEW
SILENCE/RESOUND
ALARMS
ESC
OK
FIRE ALARM SYSTEM
COMPLIES WITH
-2: 1997 / AC: 1999
EN54-4: 1997 / AC: 1999
EN54
If any detector detects a pre-alarm condition, the
STATUS - PRE-ALARM
will light up AMBER.
LED
CALL THE MAINTENANCE ENGINEER
1.12 IF THE PANEL DISPLAYS A PRE-ALARM
If the system detects a fault, the STATUS - FAULT
will light up AMBER.
LED
CALL THE MAINTENANCE ENGINEER
OPERATION
JUNO-NET
1.11 IF THE PANEL DISPLAYS A FAULT
14
JUNO-NET EN-54
MAINTENANCE MANUAL
21-08-2005
REVISION 1.0
OPERATION &
ss
ss
1.10.4 ENABLE / DISABLE ZONES
In order to Enable/Disable a zone follow the procedure described below:
1 - Enter either a valid User or Programming Code.
2 - Select Function 3.1 (Zones Disable/Assign), using the
arrow keys or the arrow keys on the either
the Infrared remote control or a PS2 keyboard. Press OK/Enter when menu 3 is reached.
3 - Using the
arrow keys once more, select function 3.1 and press OK/Enter.
4 - Select the zone to be disabled using the
arrow keys and press OK/Enter.
5 - The present status of the zone is shown. To change it, press OK/Enter and change the status using the
arrow keys from enabled to disabled and vice versa. When selection is complete press OK/Enter. To
exit press the ESC key. Each consecutive press of the ESC key will revert back one step.
If any zones are disabled during this time, the DISABLED LED in the STATUS area of the panel's fascia will
be lit. The DISABLED LED in the QUEUE REVIEW area will also be lit. If the latter LED flashes, this gives the
indication that more than one disblement has taken place in the system. To scroll through these multiple
disablements, press the DISABLED button in the QUEUE REVIEW area.