Page 16
Global Water
●
(800)876-1172
●
www.globalw.com
Sensor Installation
You can connect 2-wire or 3-wire sensors to the
GL400. Before connecting a sensor, first discon-
nect the battery spade lugs from terminals.
red (+) terminal
black (-) terminal
Note, the following instructions and screenshots specifically refer to the GL400-7-1. If you have purchased
the GL400-1-1, you will only be able to utilize analog channel 1 (
C1
) and the pulse channel (
Pulse
).
You can connect analog sensors to chan-
nels 1 – 7 (
C1 – C7
) on the terminal strip
and a pulse sensor to the
Pulse
channel.
Note, you can connect an external power
source to the
Ext.
terminals, located be-
low the internal battery (
Batt.
) terminals.
battery terminals
analog channels 1 – 7
pulse channel
Chapter 2
To connect a sensor thread sensor cable through an enclosure strain relief, and attach cable wires to the
channel terminals. Before inserting wires into terminals you may need to loosen terminal screws.
For 2-wire analog sensors, insert black wire into the
S
(signal) terminal and tighten until secure. Next, in-
sert red wire into the + (power) terminal and tighten until secure.
For 3-wire analog sensors, insert black wire into the – (ground) terminal and tighten until secure. Next, in-
sert white wire into the
S
(signal) terminal and tighten until secure. Finally, insert red wire into the +
(power) terminal and tighten until secure.
2-wire:
ter/S
3-wire:
ter/S/-
