Wall Mounted Water Bottle
Refilling Station
8
Assembly Instructions
Valve Control
• Ensure both water control valves are turned to the
closed position.
• Attach 2 screws (not included) through the frame
of the Cooling System and into the bottom support
holes previously drilled into the wall.
• Connect the building's water supply to the Filter
Head Connection. This connection must be made
through the back of the Cooling System.
• Connect the internal drain line to the building's
external drain. This connection must be made
through the back of the Cooling System.
Install water filter
• Remove the receiver protective cover from the
water filter.
• Insert filter into the filter head by turning clockwise
until locked into place.
• Turn both water control valves to the open position.
• Check all connections for leaks. If leaks are
detected ensure all connections are tight and are
fully inserted.
11
13
12
Closed
Closed
Closed
Open
• Open the water control valve
labeled “sensing spout”
• Keep the water control valve
labeled “basin bubble” in the
closed position.
(CHECK FOR LEAKS)
Water Control Valves
Wall mounting
hardware not
provided
Water Filter
Counter clockwise to remove
Clockwise to install
Connect filter
head to water
supply
9
Note:
If cooling system is on its side or back
for more than 10 minutes, allow it to stand in
the upright position for 24 hours before water
connections and initial power-on.
• Turn on buildings water supply and
check all connections for leaks.
• Fix any leaks before continuing.
• Plug power cord into outlet.
Check local codes for plumbing requirements
prior to installation.
b82045fc-0b136962-90871f19-f891407c
