Release the spring (10), slide off the splint pin (11)
and disconnect the transmission release control rod
(12).
The group is supported by a support (13) fixed by a
screw with nut (14) and is fixed to the chassis by four
screws with relative nuts (15).
Loosen the nut (16) to allow a minimum of movement
for the support (13), unscrew the nut (14), then care-
fully unscrew the nuts (15) on the four lower screws,
suitably supporting the group so it cannot fall and tak-
ing into account it weighs approximately 15 - 22 kg.
To reassemble, reverse the order of the previous op-
erations.
Check that the spacers (17 - 18) are correctly fitted to
the shafts.
Reattach all the connections, and then …
Check the brake [see 4.3]
Refit the engine pulley [see 5.5] to release the
belt.
Refit the rear wheels [see 6.1].
Lift the wheels cover [see 2.5].
Adjust the travel and the position of “neutral”
for the lever [see 4.4.A].
Tightening torques
14-16
Screws for support fastening ..... 25 ÷ 30 Nm
15
Rear axle fastening nut .................... 25 ÷ 30 Nm
3/2015
72FL hydro
5.7b
.
0
- REMOVAL OF THE REAR AXLE
(Hydro Gear T2-BDBE-2X1A-16X1)
2 / 2
쑮
쑮
쑱
쑱
WORKSHOP MANUAL
pag.
MODEL YEAR 2016
© by GLOBAL GARDEN PRODUCTS
17 18 18 18
15
15
13
14
16
10
11
12
<= ...BACK... <=
