© by GLOBAL GARDEN PRODUCTS
72FL hydro
6.1
.
0
REPLACEMENT OF TYRES AND WHEELS
1 / 1
쑮
쑮
쑱
쑱
WORKSHOP MANUAL
pag.
MODEL YEAR 2016
3/2015
6.1 REPLACEMENT OF TYRES AND WHEELS
A) Tyres
Tyres used can be:
- "Tubeless" type,
- with air chamber,
and so every repair of a hole in the tyre must be do -
ne by a tyre specialist according to the methods u sed
for each type of tyre.
After replacing one or more tyres or the wheels, it is
al ways necessary to check the pressure and to check
the alignment of the cutting deck [see 4.5].
WARNING
Replace distorted wheel rims as they could impair the
tyre’s hold.
B) Wheels
The wheels are held by a snap ring
(1)
which can be
removed with the help of a screwdriver.
NOTE
If a wheel is jammed onto the shaft, use a releasing
spray directed around the splining hole.
On assembly it is advisable to spread grease on the
shaft to facilitate the next wheel removal.
• For the front wheels:
replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing in -
wards.
NOTE
For tyres with air chamber, install a spacer (4) in side.
• For the rear wheels:
replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing in-
wards and check the axial gap of the wheel on the
shaft; if it is greater than 3 mm, a spacer (3) must
be fitted between the wheel hub and the shoulder
wa sher (2).
Tyre pressures
Front ........................................................... 1.5 Bar
Rear ........................................................... 1.0 Bar
4
3
2
1
1
2
<= ...BACK... <=
