Page
•
globalcontract.com
1
• Summer 2017
GLOBAL
Contract
TABLE OF CONTENTS
Panels
Quick Connect Clips
Lock Clips
Panel Trims
CAPAS Privacy Glass
Post Base Covers
Electrical
Power Distribution Harness
Installing Through Corners
Ceiling Feed
Post Extension
Raceway Covers without Knockouts
Raceway Covers with Knockouts
Raceway Knockout Covers
Cantilevers Corner Brackets
Mid Span Support Bracket
Worksurface Mounting Option
CHMEG Metal End Gable
Centre Mounted Overhead
Pedestal Brackets
Overhead Storage Bins
Low Profi le Shelves
Tackboards
Load Bar
ADA Overhead
Mid Run Panel Removal & Top Horizontal Replacement
Core Replacement
Chicago J-Box
Module replacement
End Panel
Accessory Retainer
01
02
02
02
03
04
04
05
05
06
06
07
07
07
08
08
08
09
10
11
12
13
14
14
15
15
16
16
17
18
19
Compile
P.01
Safety Glasses
Allen Key
Wrench
Flathead Screwdriver
Phillips Screwdriver
Measuring Tape
Required Tools
NOTE: Any alterations to listed components will void the manufacturer’s warranty.
The manufacturer will not be responsible for any damage or bodily harm caused
by alterations in accordance with national or local electrical codes and manufac-
turer’s specifi cations. In accordance with the manufacturer’s policy of continual
product improvement, the product presented in this document is subject to
change without notice or obligation.
Please contact your Global Contract Service Representative at 416-739-5000 for
any questions or concerns.
Panels
PANELS come from the factory with the “Quick Connect” clips pre-installed on both
sides of the panels. One side is pointing up and the other side is pointing down.
UNIVERSAL CORNER POSTS come from the factory with the “Quick Connect”
clips pre-installed on 3 sides. One side is pointing down, and 2 adjacent sides are
pointing up.
Slide connections together, and press fi rmly in place.
Do not use hammer to try
to secure panels.
Leveling Tip:
• If panels don’t line up exactly, please lower the glide on the lower panel to level
the panels.
Corner Post Tips:
•
Align the “Quick Connect” clips on the fi rst panel of a run so both sides point UP.
This will allow the Corner Post to be dropped onto one side, and the adjacent
panels to also be dropped on. Then the rest of the panels in the run can be easily
dropped onto each other.
• For 2 ways, remove one set of clips by loosening the set screw, and slide up and
out, through the channel. Snap in 2 Post Trim Strips to fi nish 2 open sides.
• For 3-ways, snap in Post Trim Strip to fi nish 4th side.
• For 4-ways, install the clips on the 4th side facing up, so the panel can be
dropped on.
