Page
•
globalcontract.com
11
• Summer 2017
GLOBAL
Contract
INSTALLATION GUIDELINES
Compile Pedestals come shipped with cardboard protection on top, bottom and all four
corners, and then shrink wrapped.
Compile Pedestals may be stacked up to 3 high, in the shipping trailer, during
delivery.
All Worksurface Supporting Pedestals ship with holes punched in the tops, on all
four corners, to allow simple attachment to worksurfaces., using wood screws
less than 1” long.
Compile Pedestals ship with leveling glides on all four corners. Please use a drill,
with standard drill bit extension, to level pedestal to proper height, prior to attach-
ing screws to worksurface.
Ensure that all panels are leveled and securely connected before proceeding with
installation of worksurfaces supports.
STEP 1: Align the fi rst bracket’s edge with pedestal’s top corner and rear vertical edge
as illustrated.
STEP 2: Secure the top bracket with supplied, self-drilling, counter-sunk head screws.
STEP 3: Align the second bracket’s bottom edge with pedestal’s bottom corner and
rear vertical edge and secure it with supplied, self-drilling, countersunk head screws.
(Not shown).
STEP 4: Angle the pedestal on the fl oor and insert bracket ends into panel’s vertical
side groove.
STEP 5: Rotate the pedestal while making sure that both brackets remain securely
engaged inside the panel’s vertical side groove. Install worksurface support on the
opposite side of the worksurface as specifi ed. Rest worksurface on both supports.
STEP 6: Adjust pedestal’s levelers to level the worksurface and ensure that the pedes-
tal’s side is perpendicular to the panel.
NOTE: Read before you proceed with the next step! If you use a full depth pedestals
( 24” deep pedestal under 24” deep worksurface) to secure worksurfaces to a panel
with optional Panel cable manager, do not bolt the pedestal to the worksurface yet.
You may have to angle and slide the pedestal partially out in order to gain an access
to the panel’s cable manager. In this case, the following step (#7) should be done at
the end of the installation, after all cables had been tucked away in the Panel cable
manager.
STEP 7: Remove drawers, pre-drill the pedestal top and drive two wood screws
through the pedestal top, into the worksurface. Replace the drawers and secure the
opposite side of the worksurface to its support.
TOP
BRACKET
BOTTOM
BRACKET
Pedestal Bracket / Corner Plate
1
2
4
5
6
7
