![background image](http://html1.mh-extra.com/html/global-contract/compile/compile_installation-manual_2232714003.webp)
•Page
globalcontract.com
2
• Summer 2017
GLOBAL
Contract
Quick Connect Clips
Lock Clips
Add or remove “Quick Connect” clips with a Phillips screwdriver, by loosening the
screw enough to allow the clip to slide freely.
To remove clip, lift tab on top of panel and slide clips out of groove.
To change clip orientation, use the following hole confi gurations.
• Top hole to have clip point down.
• Bottom hole to have clip point up.
Post: (a)
Put the lock clip in such a way that the short end of the clip is over the top connector
and the longer side is facing the panel (even if it’s on an angle). Using a mallet and a
fl at screwdriver, hammer the lock clip down until you feel it catch the lower screw.
Between Panels: (b)
Put the lock clip in such a way that the short end of the clip is over the top connector
and the longer side is facing the panel. Using a mallet and a fl at screwdriver, hammer
the lock clip down until you feel it catch the lower screw.
Releasing the lock clip:
Pull the leveler (sdjustor) downat the panel that it’s connector is on top and push the
other panel down.
INSTALLATION GUIDELINES
Panel Trims
Panel / Post Trims can snap or slide into place, to fi nish panel End of Runs, 2-way,
3-way and step down-variable height connections.
NOTE: End of Run Trims are approximately 5” longer than Post Trims.
a
b