Tools Required - For installation of
Your Shower Enclosure
Safety glasses
Measuring tape
Pencil
Hack saw or chop saw
(for stainless steel)
Miter Box or Square
Level
Electric Drill
Center Punch
Rubber Mallet
1.
Header Wall Brackets
2
2.
Header
1
3. Inside Roller Door Stop
2
4. Outside Roller Door Stop
2
5.
Glass Door
2
6.
Inside Door Roller Assembly
2
7.
Outside Door Roller Assembly
2
8. Flat Head Screws, #8 x 1 1/4”
7
9. Plastic Wall Anchors
7
10. Center Guide
1
11. Roller Adjustment Wrench
2
12. Curb Dam
1
13. Center Guide Leaf
4
14. Hex Key Set (4)
1
15. Towel Bar Assembly
2
16. “A” Vinyl /Bumper
2
17. Clear “H” Vinyl
1
Parts Description
ITEM NO. DESCRIPTION QTY.
Drill bit, 5/16” masonry
(for installation on ceramic
tiles or marble)
Power screwdriver
#2 phillips screwdriver
Caulking gun
Cutting Pliers
Suction Glass Lifters
(rated for more than 100 lbs)
WARNING: TO INSTALL ON CAST IRON,
FIBERGLASS, ACRYLIC OR RESIN TUB
OR SHOWER BASE
Check with the tub or shower base
manufacturer to
determine the tooling required.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
:
GlassCrafters recommends the installation be performed by
a trained installer.
• Read the manual and become familiar with the steps
involved in installation.
• This product requires
Two Persons
for safe installation.
• Always wear safety glasses during this installation.
• The proper dimensions for this installation were submitted
at the time of order. The two doors may overlap to
accommodate minor smaller opening. One end of the Header
many be cut with a Hacksaw for stainless steel, but it must fit
completely in the Header Wall Brackets for a safe installation.
• When installing any mechanical parts through the
pre-drilled holes in the glass door and panel be sure to use
the gaskets and bushings supplied between any metal
element and the glass. Do no overtighten any fittings.
• If the installation is over ceramic tiles the wall Jamb must lay
flat on these tiles for the entire height of the unit.
• Silicone Sealant is used to seal some parts during
installation.
2
CAUTION:
Risk of injury or product damage. Do not attempt to cut tempered glass.
IMPORTANT!
Children should be supervised at all times while in Tub/Shower Enclosure.
IMPORTANT!
Never use Door Handle to support yourself. This is for towels or wash cloths only.
PLEASE STOP THE INSTALLATION AND CONFIRM WITH FACTORY IF THE ACTUAL NUMBER OR TYPE OF PARTS IS DIFFERENT.
90°
B
90°
THIS MANUAL IS FOR INSTALLATION OF THE EQUALIS SERIES™
FRAMELESS -BYPASS FOR SHOWER STALL OR TUB ENCLOSURES
THE EQUALIS SERIES™ FRAMELESS -BYPASS IS ALSO
AVAILABLE WITH RETURN
FOR BOTH SHOWER STALL OR TUB ENCLOSURES.
THE RETURN CONFIGURATION HAS A
SEPARATE MANUAL FOR THE RETURN.
TUB
STALL
