6
STEP 4
.
Position for second Header Wall Bracket --
.
Extend the pencil centerline from the marked center
line on the curb and use a plumb or level to determine
the correct vertical position.
Detail 4A
Detail 5A
Detail 5B
Detail 5C
NOTE: With a plumb or
level create an extension
of the curb centerline on
the wall in the same
manner as shown in
Detail 2B.
Using a level and
the template
mark the location
for the second
Header Bracket.
Drill the holes and fasten the left
side Header Bracket to the wall.
To check that the header
is exactly level hold the
bracket and the header in
place on the template and
check with a level.
IMPORTANT NOTE: The header must be exactly
level to insure the correct operation of the
doors. If the header is out of level the doors will
not close properly.
STEP 5
. If the curb is out of square, the location
of the second header bracket will not align as
level. The difference will be the out-of-square
measure at the curb.
Use a level to determine the exact position as
follows:
• Place the second side wall Header Bracket on
the Header — loosen the set screws to slide
onto the Header —and place the other end of
Header in the installed Wall Bracket.
NOTE: When placing the header into the bracket squeeze each
end to be sure that the stainless steel cladding is tight against
the aluminum header bar to avoid bending and
damaging the header finish
.
• Lower the Header with the installed Wall
Bracket into position as aligned centered on the
marked vertical centerline.
• Use a level to determine the correct level
position for the second Wall Bracket.
• Mark the top and outside of the Wall Bracket
and then remove the header and place the Wall
Bracket in position.
• Mark for the installation holes.
• Drill and install the second Wall Bracket.
After drilling
the holes for
the Header
Bracket add
silicone to each
hole and put
the anchors in
place.
Fasten with the
flathead screws
supplied.
NOTE: Install the Header after Steps #6 & 7 in
Step #8 on page 8.
