Glamox CT Series, User Manual

Page: 13 / 48

13
LINK UP?
NEXT YES
SELECT ZONE 1-24
00 OK
PRESS F > 5 S
NEXT CANCEL
SF, SM, SX
CR-
LINK UP
LINK UP enables you to decide which receivers will follow the programming for each zone. Only when a receiver is linked to a
zone, will it be able to follow the commands transmitted by CT-. When LINKING UP is in progress your receivers learn to follow
instructions from your remote control only. In this way, systems in neighbouring houses will not interfere with each other.
Also, several systems may be used in the same building at the same time.
SELECT ZONE. You will now see a column chart with 24 columns, each representing
a zone. Zone 1 is the first column from the left, zone 2 is the 2nd column, and so on. Tall
columns represent zones that are programmed. Heating zones are from 1 to 16 and relay
zones from 17 to 24.
Type in the desired zone number. Confirm with OK.
LINK UP? Press the left-hand option key until LINK UP? appears in the display.
Confirm with YES.
For CR-, plug-in thermostats, and CO-e:
Press and hold down the button marked F for more than 5 seconds. The display will flash
and show the chosen zone. Link-up is now successful.
For SF-, SM- and SX-:
Press in and hold down the joystick until 1rF is displayed. Press once lightly on the
joystick and the thermostat shows the zone number that you have chosen on the remote
control. Link-up is now successful.
CT will stay in link-up mode for appr. 2 minutes. During this time, several units may be
linked to the same zone. For further zones, press NEXT.
Put CT into Link-up mode. We recommend that you make programmes for all zones before linking the thermostats to the remote
control. When this is done, go to LINK UP in the remote control menus. It is best to take the remote control into the room where the
thermostat in question is located. Type in the zone number when CHOOSE ZONE is displayed on the remote control, and press OK
to confirm. Then, PRESS F is displayed. >5s.