24
ENGLISH
assessment.
there are 2 conditions under which the signal of
IHb will be displayed:
1) the coefficient of variation (CV) of pulse period >25%.
2)
the difference of adjacent pulse period≥0.14s, and the number of such
pulse takes more than 53 percentage of the total
number of pulse. 12. please do not use the cuff other than supplied by the
manufacturer,
otherwise it may bring biocompatible hazard and
might result in
measurement error.
13. the monitor might not meet its performance specifications or
cause safety hazard if stored or used outside the specified
temperature and humidity ranges in specifications.
14. please do not share the cuff with other infective person to avoid
cross-infection.
15. medical aC adapter which output is DC 6.0V 600ma and complied
with IEC 60601-1/En 60601-1/UL 60601-1 and IEC 60601-
1-2/En
60601-1-2/UL 60601-1-2 is suitable for this monitor. please
note that
the monitor jack size: hole Ø 5.5mm, center pin Ø 2.0mm.
please pay attention to polarity.
16. this equipment has been tested and found to comply with the limits
for a Class b digital device, pursuant to part 15 of the fCC rules.
these limits are designed to provide reasonable protection
against harmful interference in a residential installation. this equipment
generates, uses and can radiate radio frequency energy and, if
not
installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there
is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on,
the user is encouraged to try to
correct the interference by one or more
of the following
measures:
- reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from
that to
which the receiver is connected.
- Consult the dealer or an experienced radio/tV technician for help.
17. this blood pressure monitor is verified by auscultatory method.
It is recommended that you check annex b of anSI/aamI
Sp-10:2002+a1:2003+a2:2006 for details of verification
method
if you need.
Setup and operatIng procedureS
1. Battery loading
a. open battery cover at the back of the monitor.
b.
Load four “aa” size batteries. please pay attention to polarity.