25
ENGLISH
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in metres
(m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output
power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1
At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2
These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
Warning
Active medical devices are subject to special EMC precautions and they must be installed and used in accordance with these guidelines.
Electromagnetic fields can affect the performance of the device, so other equipment used near the equipment must meet the appropriate EMC
requirements. Mobile phones, X-rays, or MRI devices are possible interference sources, as they emit high-intensity electromagnetic radiation.
The use of ACCESSORIES, transducers and cables other than those specified, with the exception of transducers and cables sold by the
MANUFACTURER of the the device as replacement parts for internal components, may result in increased EMISSIONS or decreased IMMUNITY of
the ME EQUIPMENT or ME SYSTEM.
The device should not be used when they are close to or stacked with other equipment, if necessary, please observe and verify that they can
operate normally in the configurations.
Devices or systems may still be interfered by other equipment, even if other equipment meets the requirements of the corresponding national
standard.
The device requires special precautions for electromagnetic compatibility (EMC) and requires qualified personnel to install and use in accordance
with the EMC information provided below.
The device should not contact the pins of connectors marked with an ESD warning symbol, unless electrostatic discharge precautions are used, the
device should not connect to these connectors.
In order to avoid the accumulation of electrostatic charge, it is recommended to store, maintain and use the equipment at a relative humidity of
30 % or more. The floor should be covered with ESD dissipated carpets or similar materials. In the use of the components, non-synthetic clothing
should be wore.
In order to prevent electrostatic discharging to the ESD-sensitive parts of the device, the personnel should contact the metal frame of the
components or the large metal objects near the device. When using the device, especially when it is possible to contact the ESD-sensitive parts of
the device, the operator should wear a grounded bracelet designed for ESD-sensitive devices. For more information on proper use, please refer to
the instructions provided with the bracelet.
All potential users are advised to understand the ESD warning symbols and receive training on ESD precautions.
The most basic content of the ESD precautionary procedure training should include an introduction to electrostatic charge physics, voltage level
in the conventional case, and damage to the electronic components when the operator with electrostatic charge contacts them. In addition,
the methods for preventing electrostatic buildup, and the manner and reasons for the release of human body static electricity to the ground or
equipment frame or the use of a bracelet to connect the human body to the equipment or the ground before establishing the connection should
be described.
The following cable types must be used to ensure that they comply with interference radiation and immunity standards:
Name
Length (m)
Power adapter cable
1.5
GIMA WARRANTY TERMS
The Gima 12-month standard B2B warranty
Disposal: The product must not be disposed of along with other domestic
waste. The users must dispose of this equipment by bringing it to a specific
recycling point for electric and electronic equipment
