20
If the overfill security system it’s activated, don’t proceede with the liquid aspiration. If the overfill security
system doesn’t work there are two cases:
1
st
case – If the overfill security system doesn’t work the aspiration will be stopped by the bacteriological filter
who avoids the liquid penetration inside the device.
2
nd
case – If both the security system and the bacteriological filtrer do not work, there is the possibility that
liquid has leaked inside the device, in this case return the device to GIMA technical service.
GIMA S.p.A. will provide upon request electric diagrams, components list, descriptions, setting in-
structions and any other information that can help the technical assistance staff for product repair.
BEFORE EVERY CHECKING OPERATION, IN CASE OF ANOMALIES OR BAD FUNCTIONING,
PLEASE CONTACT GIMA TECHNICAL SERVICE. GIMA DOES NOT GIVE GUARANTEE IF INSTRU-
MENT, AFTER THE TECHNICAL SERVICE CHECKING, APPEARS TO BE TAMPERED.
INSTRUCTION FOR USE
• The device must be checked before each use in order to identify any operating faults and/or damage due
to transport and/or storage.
• The work surface must be flat and stable in order that the control panel can be reached and so that the
vacuum gauge, vase and antibacterial filter are clearly visible.
• It is recommended not to hold the device in your hand and/or avoid prolonged contact with the body of the
device.
WARNING: For correct use, position the suction unit on a flat and stable surface, thus maximising the
available volume of the vase and improving the efficiency of the overflow device.
Operation with AC/DC power pack:
• Connect the short silicone tube with the antibacterial filter to the suction port. The other tube, connected to
the filter on one end, must be connected to the spout on the vase lid with the float assembled inside (over-
flow device). The overflow device is triggered (the float closes off the internal lid fitting) when the maximum
volume (90% of the effective vase volume) is reached, thus preventing the liquid from penetrating the inside
of the machine. The device must be used on a flat, horizontal surface.
• Connect the long silicone tube to the free spout on the lid; the free end of the tube must be connected to
the conical fitting for the probe coupling, to which the suction probe must then be connected.
• Connect the universal power pack to the device using the dedicated connector and insert the power cord
plug into the socket. To start the treatment, press the switch into position I to turn the device on
• Set the desired vacuum level (Bar / kPa) through the vacuum regulator. Turn the knob in a clockwise direc-
tion to increase the vacuum level: these values can be read on the “vacuum gauge”.
• To suspend and/or end the treatment, press the switch again and pull the plug out of the socket
• To mitigate the formation of foam inside the vase, unscrew and remove the lid from the vase, and fill the
latter with 1/3 water (to facilitate cleaning operations and speed up depressurisation during operation), then
screw the lid back onto the vase.
• Remove the accessories and proceed with cleaning operations.
• At the end of each use place the device back in the box, protected against dust
WARNING: The power cord plug is the element of separation from the electrical mains, even if the device is
equipped with an on/off button. Once the device is in use, the power plug must remain accessible to allow
another method of disconnection from the electrical mains.
ENGLISH
10. Noisy
Technical internal problem
Contact the technical service
Faults 1 - 2 - 3 - 4 - 5 - 6 - 7
- 8 - 9 - 10
None of the remedies has achieved
the desired results
Contact the seller or GIMA After-sales Assis-
tance Service
