5
Model: RT-5
Installation
2.
Installation
This section provides a summary of procedures necessary to install your new Giles Rotisserie,
Model RT-5. Before installing or servicing this equipment, please read the contents of this manual
thoroughly. Following these procedures will help ensure a safe and proper installation.
Your unit should arrive packaged in a wooden crate, covered with plastic shipping wrap, and secured to a
wooden platform by means of high-tensile strength strapping. Perform the following steps to uncrate the
unit:
1.
Position the packaged RT-5 in an area with sufficient room for unpacking.
2. Cut and remove the plastic shipping wrap and any high-tensile strength straps from the exterior of the
wooden crate.
3. Carefully use a hammer and pry bar to remove the wooden crate from around the unit.
4. Cut and remove the plastic shipping wrap and high-tensile strength strapping that secures the unit to
the wooden platform.
5. Before installing, check the unit for damage. If unit was damaged during shipment, notify the carrier
immediately and file a claim.
6. Carefully remove the unit from the wooden platform and place at the installation site.
7.
Using wire cutters, cut all plastic ties holding Spits or Baskets and Spit Wheel Assembly in place.
2-01. Unpacking
NOTE:
•
If the crate is damaged, immediately inspect the unit and notify the carrier of any damage to the unit.
•
Exercise care when lifting or moving the unit, please see Section 1-03.3 for unit weights.
•
Exercise care when removing the wooden crate from around the unit.
!
CAUTION
Summary of Contents for RT-5
