GILES FSH-4 Hood, Operation & Service Manual

Page: 35 / 68

25
Model: FSH-4 Hood Operation & Filter Maintenance
Be sure that all filters are in place and both filter Access Doors are closed and latched securely before attempting to
operate the unit. NOTE: The hood will NOT power-up if either filter door is open, or ajar.
4. Operation & Filter Maintenance
4.01 Starting the Hood
4.02 Filter System, Filter Maintenance & Filter Alarms
4.02.1 Ventless Hood Filter Table
Filter
When to
Clean/Replace
How to Remove How to Clean How to Install
Baffle Filter Clean daily Section 4.02.2 Section 4.04.1 Section 4.02.3
Pre-Filter
Replace every 7 to 10
days
Section 4.02.4
DO NOT attempt to
clean; ONLY replace!
Section 4.03.4
Section 4.02.5
E.A.C. Filter Cell Clean daily Section 4.02.6 Section 4.04.2 Section 4.02.7
Charcoal Filter
Replace every 30 to 40
days,
Section 4.02.8
DO NOT attempt to
clean; ONLY replace!
Section 4.03.5
Section 4.02.9
1. Press and momentarily hold the top [START] portion of the
Power Switch ① until the hood blowers start running.
Release and switch will spring back to remain ON .
2 The green HOOD POWER light ② and both small EAC
[ON] lights ③ should turn ON . A constant tone alarm
may sound briefly and stop as the fan reaches full speed.
3. At that time, the amber APPLIANCE POWERED light ④
should turn ON to indicate that power is now being
supplied to the fryer and it is ready for use.
4. Place Light Switch ⑤ in [ON] position to turn on under-
hood lighting
Should this sequence not occur or should any other lights turn ON, see the Section 6, Troubleshooting for
possible cause and corrective action.
To Start the Hood:
1. Press the bottom [OFF] portion of the Power Switch ① .
2 Blower stops and all indicator lights turn OFF .
3. Power to the fryer is shutdown.
To Shutdown the Hood:
1
2 3
4
5