Gilera Nexus 250 i.e., Manual

Page: 23 / 96

01_22
Immobilizerdeviceenabledindicatorled (01_22)
Activation of the «PIAGGIO IMMOBILIZER» system is signalled by a flashing « G »
warning light. In order to reduce battery discharge, the indicator LED turns off auto-
matically after 48 hours of uninterrupted functioning. Should the signal led system
break down in its flashing function, give information about the type of problem to an
Authorised Piaggio-Gilera Service Centre .
Operation
Every time the starter key is extracted from either the « OFF » or « LOCK » position, the
protection system activates the engine lock. Turning the key to « ON », with the engine
cut-off switch set to « ON » and the side stand up, disables the engine lock provided
that the safety system recognises the code transmitted by the key. If the code is not
recognised, turn the key first to "
OFF " and then to " ON "; if the lock cannot be disabled,
try with the other key supplied (red-coloured). If it is still not possible to start the engine
it is absolutely necessary to turn to an
Authorised Piaggio-Gilera Service Centre
that has the equipment necessary for diagnosis and repair of the system. The immo-
bilizer is also activated when the engine cut-off switch stops the engine or the side
stand is lowered. This happens even if the starter key is in position "
ON ". When ad-
ditional keys are required, please note that data storage (up to 7 keys max.) must be
done on all keys, both new ones and existing ones. Take the red-handgrip key and all
the black keys supplied to an
Authorised Piaggio-Gilera Service Centre . The codes
of keys not submitted for the new storage procedure are deleted from the memory.
Any lost keys will therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
23
1 Vehicle