Gilat Satellite Networks SkyEdge II, Installation Manual

Page: 26 / 34

SkyEdge II VSAT Installation and Monitoring
Table 2: LED Boot Sequence
Mode LED Status
PWR On
Tx Flash On and Off
On-Line Flash On and Off
SYNC Flash On and Off
Rx Flash On and Off
Tx Flashes On and
Off for 5 seconds
Boot
Mode
Rx On
Rx Off
Rx On
SYNC On
Tx Flash On and Off
On-Line On
SYNC Off and On
Operational
Mode
Tx Flashes
At this point the VSAT should be operating normally and web browsing can
successfully carried out.
3.4.2 Monitoring via the SkyManage Web Page
This section details what is shown on the SkyManage web page after successfully
assembling the ODU and antenna and pointing the antenna, the IFL (coax) cables are
connected to the VSAT, the power switch is turned on or the external power supply
is plugged in and the VSAT is reset as shown in Section
2.4. The captures in this
section are from different pages on the web site.
1. The Outbound locks on while the VSAT is still in Boot code mode.
2. The VSAT downloads the software tables.
3. The Outbound locks on in Operational code mode.
SE VSAT Install and Monitor
May, 2007
20
Proprietary and Confidential