120
Appendix
Gigaset S675 IP / ALGERIAN eng / A31008-M1915-A751-1-3T19 / appendix.fm / 27.10.08
Ve
rsion 4, 16.09.2005
Appendix
Care
Wipe the base station, charging cradle and
handset with a
damp
cloth (do not use
solvent) or an antistatic cloth.
Never
use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1.
Switch off the handset and remove
the battery pack immediately
.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place
for at least 72 hours
(
not
in a microwave, oven etc.).
4.
Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at
www.gigaset.com/customercare at any
time. The table below contains a list of
common problems and possible solutions.
!
Please note:
To support the service team, it can be helpful if
you have the following information to hand:
– Version of firmware, EEPROM and your
phone's MAC address
You can check this information with the
Web configurator (page 119). For how to
display the MAC address on your handset,
turn to page 91.
– VoIP status code (page 123)
For problems with VoIP connections, you
should set VoIP status messages to be dis-
played on your handset (page 89,
page 116). These messages contain a sta-
tus code that helps when the problem is
analysed.
The display is blank.
1. The handset is not switched on.
¥
Press
and hold
the end call key
.
2. The battery is flat.
¥
Charge the battery or replace it
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and
hold
the hash key
"Base X"
flashes
on the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base
station.
2. The handset has been de-registered.
¥
Register the handset (page 73).
3. The base station is not turned on.
¥
Check the base station's mains adapter
4. The base station firmware is currently being
updated (page 88/page 116).
¥
Please wait until the update is complete.
"
Base Search
"
flashes in the display.
The handset is set to
Best Base
and no base sta-
tion is turned on or within range.
¥
Move the handset closer to the base sta-
tion.
¥
Check the base station mains adapter.
