Gigabyte R282-Z96, User Manual

Page: 34 / 143

System Hardware Installation - 34 -
3-6 Removing and Installing the GPU Card
• Voltages can be present within the server whenever an AC power source is connected. This
voltage is present even when the main power switch is in the off position. Ensure that the system
is powered off and all power sources have been disconnected from the server prior to installing a
GPU card.
• Failure to observe these warnings could result in personal injury or damage to equipment.
• The GPU card assembly does not include a riser card or any cabling as standard. To install a
GPU card, a riser card must be installed.
Follow these instructions to install a GPU card:
1. Loosen the thumbnail screw securing the riser bracket from the rear side of the system.
2. Loosen the two thumbnail screws securing the riser bracket inside the system.
3. Lift up the riser bracket out of system.
4. Remove the screw securing the slot cover from riser bracket.
5. Orient the GPU card with the riser guide slot and push in the direction of the arrow until the GPU
card sits in the GPU card connector.
NOTE: Some riser brackets allow for single or multiple GPU cards.
Repeat steps 4-5 as necessary.
6. Secure the GPU card with the screw.
7. Repeat steps 1-3 to install the GPU card into the system.
1