[ ]
• Dig a foundation hole with the dimensions indicated in
7
.
NOTE:
Depending on the type of ground, it is advisable to make a foundation for casting of quick-drying cement.
[ ]
• Position the operator box in the excavation respecting the indications in
8
and check that it is level.
[
]
[ ]
CAUTION:
Make sure that the centre of the operator pin is perfectly in line with the hinge of the gate leaf
2b
-
3
.
• Arrange a PVC tube of at least 35 mm diameter up to the operator cable inlet through which to run the electric
[ ]
[ ]
cables
9
. Provide for a rainwater drain pipe, preferably connected to a water recovery duct
9
.
• Embed the operator box in the foundation hole..
N.B.
Check that the cement in the foundation hole has dried sufficiently before installing the operator.
[
]
1) Fit the lever unit to the box pin
10
;
MODO 1:
[
]
2) Procure a U-bracket with the dimensions indicated in
11
;
[
]
3) Weld the U-bracket on the operator support arm
12
;
4) Position the gate in the guide bracket and hinge it in the upper part;
5) Check that the gate is on bubble;
[
]
6) Close the U-bracket on the pillar side with a plate
13
.
MODO 2:
[
]
,
[
]
2) Weld the leaf directly on the gate support arm
14
checking that it is on bubble
14
.
FOUNDATION EXCAVATION
FITTING THE GATE
Listed below are some typical conditions in which you might be operating with the relative suggestions for each one of
[ ]
[ ]
[ ]
[ ]
them
6
-
7
-
8
-
9
:
a) Gate still to be installed
:
- It is preferable to fit an adjustable type upper hinge for the leaf.
b) Gate with adjustable hinges
:
- Remove the lower hinge
[ ]
- Loosen the upper hinge and turn the leaf
6
- Embed the box
- Refit the leaf
c)
Gate with fixed hinges:
- Remove the gate
- Remove the lower hinge
If the gate cannot be removed, insert a support shim underneath the lower edge of the leaf.
EMBEDDING THE OPERATOR BOX
GROUND
21
Summary of Contents for GROUND 610
