I
UK
UK
Should it be necessary to manually operate the gate, use the manual key unlocking device
N.B.: t
power DISCONNECTED
.
he unlocking operations must be carried out only in the case of an emergency and especially with the
.
MANUAL OPERATION
TESTING THE AUTOMATED DEVICE
• Program the circuit board as required following the relative instructions.
• Power the operator and check the LED status as indicated in the table in the instructions for the electronic part.
Carefully test the automated device as well as all the accessories connected to it.
Give the customer the instructions for use and demonstrate proper functioning and use of the device, the safety
devices, cautions and warnings.
START-UP
LIMIT SWITCH FITTING AND ADJUSTMENT
[
] [
]
1) Fasten the operator checking that it is exactly positioned
15
-
16
.
2) At this stage it is advisable to grease the operator output shaft and the lever fastening pins.
[
]
3) Fit the lever on the reduction gear shaft without fastening it with the suitable plug
20
.
[
]
4) Assemble rod and pins using the cotters provided
20
.
5) If you use some electrical limit switches, refer to next paragraph before going on.
[21]
6) Fasten the lever fit at point 3 to the reduction gear shaft with the suitable plug
.
OPERATOR INSTALLATION
[
]
1) Fit the two cheese-headed screws
e 18
directly on the operator body.
[18]
[
]
[
]
2) Fasten the sensor board
c
using the two screws
f 18
above the two screws
e 18
, paying attention
to run the output cable through the grooves on the operator.
[
]
[
]
3) Taking the sensor as reference, assemble the two limit switches
19
on the disc
20
using the screws provided.
Fasten the first one in the gate-open position and the second one in the gate-closed position, moving the leaf by
hand (it is possible only if the output lever is not fastened with the suitable plug).
There are several seats on the limit switches where you can position the magnets spaced out 5°; if you use two
magnets (deceleration enable and end of motion), it is recommended to always leave at least two empty seats
between the two magnets.
Be sure to remove and put the magnets on without turning them.
[
]
If the sensor fails to read, appropriately adjust its height by loosening the retaining screws
f 18
and screwing or
[
]
[
]
unscrewing the cheese-headed screws
e 18
. When done, tighten the retaining screws
f 18
.
In any case always refer to control unit instruction for limit switches management
GROUND
22
Summary of Contents for GROUND 610
