6 | Operation
OMNIPLUS-F
28/ 45
C-E01_X__OMNIPLUS-F__DB2-1.0
6.6.2 "Reset Mode" parameter
To reset the volume counter to zero, various methods are available for selection. Only
one method can be used at a time.
Setting values:
None
No reset possible
Preset counter
The reset occurs when the preset value is reached and
counting starts again (cycle operation)
External (Pin 5)
The reset is performed by an external signal at pin 5, which must
be configured accordingly for this purpose (see "Pin5 settings")
The type of signal can be defined in "Pin 5 settings
Ring
The reset is done by going to the main menu using the multifunc-
tion ring and selecting the "Totalizer reset" entry there
6.6.3 "Preset counter" parameter
Enable or disable the preset value.
Setting values:
ON - activates the preset counter
OFF - turns off the preset counter (
the parameters described below will be
not displayed)
6.6.4 "Preset unit" parameter
Displayable units of the preset value:
Liter
m³
6.6.5 "Preset value" parameter
The preset counter is displayed in the previously set unit.
Setting values: 1 ... 999999
6.7 "Temp measuring" submenu
In addition to the flow velocity, the instrument always also measures and displays the
temperature (by
RING-TURN
in the measured value display). The displayed unit can
be selected here. The temperature can be indicated in the same way as the flow ve-
locity. The settings for this are made in the Pin Settings.
6.7.1 "Unit" parameter
Displayable units of the preset value.
Setting values:
°C
°F
K
