5 | Mounting
OMNIPLUS-F
14/ 45
C-E01_X__OMNIPLUS-F__DB2-1.0
Cutting ring fitting, stainless steel, order code ADQ012G015A, PN 40
Available in the versions:
K
Stainless steel cutting ring
K1
PTFE clamping ring
Stainless steel cutting/clamping fittings are screwed into a G ½ threaded hole. A G ½
weld-in spigot (ADG- 015GS026K) is available for this purpose. This arrangement can
accommodate pressures up to 40 bar. The screw fitting is first tightened by hand and
then further tightened by ¼ turn with the aid of a wrench. The clamping ring of the
screw fitting can then no longer be removed from the sensor, so the immersion depth
can no longer be changed.
When mounting the push-in sensors, it must also be ensured that the sensors
have a directional dependency (observe marking X on the housing)
5.5 Push-in probe with union nut and sealing cone
Insertion probe with defined immersion depth. The M18x 1.5 union nut is screwed
onto a suitable socket on the pipe side. Torque max. 40 Nm. Sealing is achieved via
the 24° sealing cone. Depending on the T-piece used, this type of mounting allows a
pressure load of up to 100 bar.
5.6 Mounting position
Arbitrary, as long as the sensor is sufficiently flushed with medium. However, prefera-
bly vertical with flow from bottom to top. Gas bubbles and / or sediment formation lead
to measurement errors and must be avoided. See also chapter 5.1 General notes.
