- 3 -
Safety Instructions
1. Avoid use
near explosive atmosphere, atmosphere of flammable gases, corrosive
atmosphere, the place possible to touch water, and combustible materials.
2. Do not work of moving from the current carrying state, connection, checking. Please
work after turn off power.
3. Connect based on the wiring diagram and make to be sure
4. In case of mount motor, control device on unit, make not to be reached by hand or
make ground.
5. Do not operate in the exposed state of the parts that is carrying current.
6. Turn off power in case of power outage and thermal protector is operated.
There are injury and danger of device when reset suddenly.
7. Avoid to touch output terminals of the control device for 30 seconds after turn off
power. There is danger of electric shock by residual current-voltage.
8. Do not use exceeding specification of motor, control device.
9. Do not put fingers or objects to closed-region of motors, control devices.
10. Do not operate with wet hands. There is a risk of electric shock.
11. Do not hold the output shaft of the motor, running region,the lead when carry.
12. Please check the actual product is same as goods ordered.
13. Use after immobilization of the motor certainly.
14. Install cover etc. to avoid contact with rotating parts.
15. Check the direction of rotation before join with machine.
16. Avoid getting on or hang down on control device, motor.
17. Do not touch Motor output shaft (spline, toothed wheel region) with the bare hands.
18. Protection device is not supplied with the motor. Install overload protection device.
It is also recommended to install the protectional device (circuit blocks, etc.) except
overload protective device. .
19. When removing the plug, do not pull out holding the plug.
There is danger of electric shock, fire.
20. Motors and control devices should be used in a given combination. There is a risk of
fire.
21. Set PARAMETER that was set to the machine before start operation after join with
Machine..
22. In case of start operation after joining with machine, set the state to stop in emergency
at any time..
23. Turn off power immediately in case of occurring abnormal state.
There are shock, injury and fire risk.
24. Do not touch to Rotors (output shaft) during operation. There is risk of injury danger by
enwinding.
25. Do not touch the hands and body on operation or after operation of the motor, control
system.
26. Do not use in area where there is a large amount of static electricity. May cause
personal injury according to a malfunction.
