- 10 -
6-4. How to Use (INDUCTION MOTOR)
RUN / STOP function
RUN / STOP function
RUN / STOP function
RUN / STOP function
6-1, 2,In basic electrical wiring of Paragraph 3, if make SW2 to the RUN side, MOTOR
rotates by the speed of rotation that was set by external speed setter, and it stops naturally
by the inertia if make to Stop side. .
RUN / braking functions
RUN / braking functions
RUN / braking functions
RUN / braking functions
6-2, At basis electrical wiring of paragraph 3, in state of put SW2 to RUN, if put SW3,
SW4 from RUN to BRAKE, MOTOR stops moment by action of BRAKE for 0.5 seconds.
SLOW RUN. SLOW STOP functions
SLOW RUN. SLOW STOP functions
SLOW RUN. SLOW STOP functions
SLOW RUN. SLOW STOP functions
Through SLOW RUN, SLOW STOP control volume of CONTROL PACK,
Can set MOTOR rotation to accelerate , decelerate slowly.
Setup time increases according to raising volume and SLOW RUN : About 30 5 seconds in
Volume MAX and SLOW STOP : is set about 35 5 seconds. It is impossible to stop SLOW
STOP shorter than the time of the natural stop of MOTOR. (Up to 60Hz : 1700 rpm, 50Hz :
1400 rpm standard).
CAUTION
1. Do not change the direction of rotation about 3 seconds after stop MOTOR when power
is applied and MOTOR stops moment.
2. When not in use for long time turn SW1 OFF to avoid the heat of
CONTROL PACK
7. Basic Electrical Wiring (REVERSIBLE MOTOR)
7. Basic Electrical Wiring (REVERSIBLE MOTOR)
7. Basic Electrical Wiring (REVERSIBLE MOTOR)
7. Basic Electrical Wiring (REVERSIBLE MOTOR)
7-1. When operate normal/reverse RUN + change of speed in REVERSIBLE
MOTOR. (6W ~ 90W)
