GFS NETLIGHT Quattro, Manual

Page: 55 / 58

system documentation quattro GB V13.docx / Page 55
Appendix 1 – Possible fault indications of the system
Error Cause Remedy
Lights missing
(Circuit LED flashes after light test)
Lights/lamp defective
No or incorrect Lights connected to the output of the circuit
module.
Incorrect type of Lights in programming
Check Lights
Check output terminals
Check programming
Fault / mains fault
Mains failure
Mains missing or mains fuse defective
Network monitor defective
Check mains supply, check mains fuse,
Check "SETUP – phase monitor" programming
Fault / local emergency operation / input X In the program, the network monitor of input X is activated,
but no voltage is connected or the voltage is faulty.
Check wiring and programming of the input.
Battery circuit error No battery connected, battery fuses defective Check battery connection, check battery fuses
Fuse error
(circuit LED flashes and fault lights up)
Output circuit fuse on the circuit module defective Check connected Lights for short-circuits.
Lights missing
e.g. Ci01 – L01 Lights defective
Incorrectly coded module.
Module defective
Replace Lights
Check the coding of the corresponding module.
Measure the input and output voltage at the module, replace
the module if necessary.
Lights missing
e.g. Ci01 – L01 and Ci01 – L01 and…….
Double-coded component.
Module not calibrated (only for MSÜ3 and standard module
with individual Lights monitoring)
Check the coding of the modules.
Perform circuit calibration
Lights in the building do not light up.
(No error message on the master display.) Continuous/backup coding on the module incorrect.
DIP switch for lamp output wrong. Check the coding of the module.
Check DIP switch
Lights failure e.g. HG – CI01
(only for SKM-Normal OC/SC)
Lights defective Check circuit for defective Lights, replace Lights.
Date + time is wrong Date + time incorrectly set
Time control function battery -A2-G2 defective/empty
Set date + time acc. to section 7.7
Replace battery acc. to section 8.2.