Second hole
used for mounting
First hole used
for mounting
OPTIONAL 4" EXTENSION PAN INSTALLATION
(KIT LBT83300)
1. The Extension Pan kit includes two footboard
mounting brackets that are used to extend the
footboard to accommodate the pan. If you already
have a Liberty bed and have purchased the 4.00"
Extension Kit, first remove your existing footboard
assembly from the bed.
2. Remove the two hair pin clips (one on each side)
from the clevis pins that attach the brackets to the
main frame tubes—detach the brackets from the
footboard by removing the four
1
/
4
-20 x 20mm bolts
from the bracket insides. Retain the bolts for the next
step. Discard the old brackets if you do not need
them for future use.
3. Attach both the left bracket (#3) and right bracket (#4)
to the inside of the footboard, reusing the four bolts
(#5) you removed in step 2.
4. Slide the new footboard assembly into the main
frame tubes so that the bracket second holes align
with the tube first holes. Use four clevis pins (#6) and
four hair pin clips (#7) to secure the brackets to the
tubes (either reuse the two sets you removed in step
1 and
two more from your kit, or all four from your kit).
5. Attach the extension pan to the foot deck—lay the
pan
on top of the foot deck so that the three bent sides
face upward and the side without any bends is
oriented toward the head end as shown.
6. Position the two oval holes at the end of the pan so
that they align with the last holes in the foot deck
(nearest the curved ends).
7. Insert a Washer (#9) onto each of the two Phillips
Pan Head Machine Screws (#10). From the top,
insert the screws and washers through the holes.
From the bottom, screw on two Flange Lock Nuts
(#11) to secure. Tighten the nuts with a
7
/
8
" wrench.
GF Health Products, Inc. - www.grahamfield.com
Liberty Series Service Manual 999-0822-190G
LIBERTY SERIES
22
For Parts Call Medical Parts Source: 941-342-7725
