INSERT FLAT TAB SO
THAT IT IS PARALLEL
WITH CASTER
CARRIAGE RAIL SLOT
TO LOCK FLAT TAB INTO
CARRIAGE RAIL, TURN
TAB IN SIDE HOLE UNTIL
WALLSAVER RESTS ON
CROSSBRACE
FINAL WALLSAVER
RESTING POSITION
WALLSAVER
ATTACHING POSITION
Wallsaver hole for 80" Bed with Trapeze
Wallsaver hole for 76" Bed with Trapeze
Wallsaver hole for 80" Bed without Trapeze
Wallsaver hole for 76" Bed without Trapeze
STANDARD WIREFORM WALLSAVER INSTALLATION
WALLSAVER ASSEMBLY
The Liberty Bed is shipped with a wireform wallsaver for the
head end of the bed. No hardware is necessary to attach this
multi-positional accessory.
To attach: bend in the tabbed ends into the slots in the carriage
rails and lock down into place. There is even a position if you
choose to install an optional trapeze support at the head end
of the bed. (See page 21 for Trapeze Support installation in the
Assist Devices section of this manual.)
WALLSAVER REMOVAL
1. To remove or move the wallsaver to a new position, raise
the wallsaver off the floor until the end tabs are horizontal.
2. Squeeze the ends toward the center of the wallsaver until
the end tabs slide out of the caster base holes.
GF Health Products, Inc. - www.grahamfield.com
Liberty Series Service Manual 999-0822-190G
LIBERTY SERIES
12
For Parts Call Medical Parts Source: 941-342-7725
