GF Signet 0252, Operating Instructions Manual

Page: 7 / 24

General Software Operation
Read Loads the data from the connected device (sensor or transmitter) and updates the software’s display.
NOTE : This will overwrite any changes made in the 0252 software since the last Write .
Write Applies the data entered in the 0252 software to the connected device. Once you have entered the desired setting
changes in the software screens, press Write to load your new settings onto the connected device.
Save Stores the entire 0252 settings configuration, as currently displayed in the application, to a specified location on your
computer. (You will be asked to select a file location and provide a file name)
Load Opens a previously saved settings configuration file. See Save function above.
NOTE: The file must be a 0252 settings configuration file.
The software will verify whether the user-selected file is the correct type.
Default Resets all data on all application screens to a factory default condition. A confirmation dialog box will be presented with
a warning explaining all un-saved configuration information will be erased.
After resetting the software to a factory default condition, click Write to reset the connected device to a factory default
condition.
NOTE: Performing the above reset to factory default condition will not change the input type on the
9900 Transmitter.
NOTE: Certain sensors, 2250, 2450, and 258X will request sensor specific information for the default setting
such as range or size.
On all screens Read, Write, Save, Load, and Default buttons can be found in the lower right corner.
Sensor Operation
Application settings: 2250 2350 2450 2750 2751
1 Engineering units in., ft, cm, m ˚C or ˚F psi, kpa, bar pH or (ORP) pH or (ORP)
Loop Output settings:
2
4 mA
Set Point
Min 0 -10 ˚C (14 ˚F) 0
0 pH
(-1000 mV)
-1 pH
(-1999 mV)
Max
-XU:
276.8 in., 23.07 ft,
703.1 cm, 7.03 m
-XL:
1384.0 in, 115.33 ft,
3515.0 cm, 35.15 m
100 ˚C (212 ˚F)
psi: 10, 50, 250
kpa: (69, 344.7,
1723.7)
bar: (0.7, 3.5, 17.2)
14 pH
(2000 mV)
15 pH
(1999 mV)
3
20 mA
Set Point
Min 0 -10 ˚C (14 ˚F) 0
0 pH
(-1000 mV)
-1 pH
(-1999 mV)
Max
-XU:
276.8 in., 23.07 ft,
703.1 cm, 7.03 m
-XL:
1384.0 in, 115.33 ft,
3515.0 cm, 35.15 m
100 ˚C (212 ˚F)
psi: 10, 50, 250
kpa: (69, 344.7,
1723.7)
bar: (0.7, 3.5, 17.2)
14 pH
(2000 mV)
15 pH
(1999 mV)
Write or Save settings:
4a
or
4b
Click “Write” to copy these settings to the product.
Click “Save” to save these settings to a local computer file for later use.
5 To use a saved file (from 4b):
1. Click “Load”
2. Navigate to the saved file
3. Select “Open”
4. Click “Write”
5. Click “Read” to confirm
7
GF 0252 Configuration Tool