15
T
ROUBLESHOOTING AND POSSIBLE
S
OLUTIONS
Problem
Possible Solutions
The console does not boot when pressing the
power button.
1
Make sure the power cord is connected correctly to electri-
cal outlet and apparatus. Live installations will cause power
button to light up. (stand-by
➔
red, on
➔
white)
The user interface freezes (no reaction to
finger gestures).
1
Perform a hard reset by holding down the power button until
the device shuts down. Try to restart by tapping the power
button again.
(If this happens in a dry environment and in absence of any
climatic extremes, please contact the customer service.)
I can hear only one pad component (e.g.
Head OR Rim).
1
Make sure that the stereo cables connecting pad and
console are plugged in completely. Regarding GEWA cym-
bals and modules, the stereo cable needs to be connected
to the socket facing the cymbal piezo.
I can´t hear any sound (Neither the Drum Kit
nor any other sounds such as playing songs
or metronome.
1
Check whether your headphones or speakers are connected
to the console correctly.
2
Make sure your output volume dials are not muted (Head-
phone, Master, Mix Input).
3
Check settings in the routing matrix and load one of the
“Factory Presets”.
General Settings
➔
Module 1
➔
Routing Drums
and Routing others
I can´t hear any sound of connected pads,
but trigger monitors respond to playing them.
Song Player and Metronome however are
both audible.
1
Check settings in the routing matrix and load one of the
“Factory Presets”.
General Settings
➔
Module 1
➔
Routing Drums
and Routing others
2
If you have worked with
MIDI
lately, a turned off
Local Control
might prevent the control data generated by the connected
hardware from accessing the internal sound engine. Check
General Settings
➔
Module 3
➔
MIDI
➔
Global MIDI Settings (Soft
Thru)
➔
Local Control
The Mix Input or Monitor-Out Volume is not
adjustable.
1
It is. By default, the corresponding dial is set to Monitor-Out.
Tap the grey button below the dial name to switch between
Monitor Out and Mix Input and try again. (Dial panel on the
left-hand side of the touch screen)
I can´t hear any metronome sound, but I can
hear the drum kit and playing songs.
1
The Metronome is likely to be muted in Visual Mode. Check
Performance
➔
Module 4 (Metronome)
➔
Visual Mode
2
The Metronome is not routed to the output you are listening
to. Check “Click” in
General Settings
➔
Module 1
➔
Routing Others
Component icons in Kit editor don´t match
the connected pad type.
1
Assign a matching trigger bank to the input channel in
question and save a new trigger setup. Icons shown in Kit
Editor are driven by the trigger bank assigned to an input
channel. (
Triggers Settings
➔
Module 1 + 2
)
I have Imported sounds using the import tool,
but I cannot find them in the sound browser
(Kit Editor).
1
Open the sound browser and check “Import” under source
on the right-hand side of the browser window. This will list only
imported sounds. Like the factory sounds, the imported
sounds are filed under the matching instrument category.
Browse the tabs.
Summary of Contents for G9
